Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) - Manual (Page 37)

Installation of ViewCheck
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49C) 37
After logging into the CLI, user can start, stop and query a test from the CLI.
Below is an example of FloodPingTest in the network interface device category. In network
interface category mode test ID 1. For more information, refer to
NETWORK on page 89 .
You can view the details of the test by giving show-test-help command.
A list of device Instances supported under a device category can be viewed by giving list-
device-instances
. To start the test, user can run start-test command with testId,
deviceInstance
and arguments as input to the command. The arguments can be
neglected for tests that does not take any arguments as input.
After the test is executed, the results can be viewed by show-test-result command,
which outputs the test result and the raw log generated by that test.
Using CLI, you can list all the Inservice diagnostics monitors in a device category. By default, all
the monitors are started when ViewCheck application is initialized. User can use start-monitor
and stop-monitor commands to start and stop any monitor.
To exit from the ViewCheck CLI:
BSF(diag-vee0)#exit
BSF(VEE-vee0)#exit
BSF(config)#exit
#exit
4.6 Access and Execution of a Test Using XML
You can access ViewCheck XML interface similar to ViewCheck CLI.
1. Establish the secure shell using SSH or Putty.
2. Start the Telnet connection from an already established secure shell.