Installation of viewcheck – Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) User Manual
Page 34
Installation of ViewCheck
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49C)
34
Trying 127.0.0.1...
Connected to localhost.localdomain (127.0.0.1).
Escape character is '^]'.
Welcome to Emerson's SSF CLI
3. Type your username and password.
Username: Admin
Password:
Access granted
>enable
#configure terminal
BSF(config)#
BSF(config)#virExecEnv vee0
BSF(VEE-vee0)#diagnostic
BSF(diag-vee0)#
After logging into the ViewCheck CLI, you can list all the commands supported by typing '?'
on the CLI console. For information on commands to be used to install and LOG to ViewCheck,
refer
BSF(diag-vee0)#?
configure-error-strings User configurable error strings, notified
by ViewCheck when reported by the device.
configure-log-path
Configures the log path where the resluts
are stored.
device-category Configure deviceCategory
diag-service Diag operation(start/stop/restart).
exit Exit from diagnostic
hw-inventory-list
Provides the Inventory of Hardware (Type,
Vendor ID, Major Number, Minor Number and
any associated Details) as detected by the
Diagnostics Application.
list-all-tests Displays all the supported tests on the
Board.
By default, the administrator user name and password are "Admin".