Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) - Manual (Page 36)

Installation of ViewCheck
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49C) 36
BSF(diag-vee0)# device-category networkinterface
BSF(diag-vee0-networkinterface)#?
exit Exit from deviceCategory
list-device-instances List all the possible device
instances in present
deviceCategory.
list-tests User can use this command to get
information on the available
Diagnostic tests with details like
tests and sub tests associated,
along with Test
IDs.
set-lower-threshold-info Set the Lower Threshold value for
the Monitor
set-rate set the rate of change value for
network monitors
set-poll-interval-default Set Poll Interval to default value
set-poll-interval Set the Poll Interval
set-threshold-default Set Threshold to default value
set-upper-threshold-info Set the Upper Threshold value for
the Monitor
show-lower-threshold-info Show Lower Threshold info.
show-monitor-id List all monitors for the
deviceCategory.
show-networkcounter-log show network counters log
show-networkerror-log show network errors log
show-poll-interval Show Poll Interval
show-rate show the rate of change value for
network monitors
show-test-help Brief help on the usage of the
Specific Test referred by Test ID.
show-test-result Show test result
show-test-status Show test status
show-upper-threshold-info Show upper threshold info.
start-monitor Start a monitor
start-test Start a test
stop-monitor Stop a monitor
stop-test Stop a test