Beisler 2111-4 - Manual (Page 40)

Short Seam Automat 2110-4 / 2111-4 Working Instructions
- C 40 -
Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.5 Machine set-up
Checking clamp travel steps:
After the toothed belt has been replaced, the number of
clamp travel steps must be checked.
At the factory, this value has been set:
•
to 00 steps at the right stop,
• to 735 steps at the left stop.
These values must be adhered to.
1. Switch machine on and allow to reference.
2. Go to diagnostics menu:
• Press
 key
• Press
 key
3. Go to clamp transport menu:
• Press  key
4. Go to clamp motor travel steps:
• Press  key
5. Confirm safety prompt:
• Press % key
6. Push clamp rail manually to the right stop. The display
must show 00 mm.
7. Push clamp rail manually to the left stop. The display
must show 735 mm.
Setting clamp travel steps:
If the result of the clamp travel step check is not 735 mm
for the left stop, switch S04 must be repositioned:
•
If the value is higher than 735 mm, the switch must
be repositioned to the left.
• If the value is lower than 735 mm, the switch must be
repositioned to the right.
1. Loosen two switch retaining screws.
2. Move switch in required direction and tighten screws.
3. Recheck number of clamp travel steps. If required, the
setting process must be repeated until the correct value
of 735 mm is displayed.