Beisler 2111-4 - Manual (Page 65)

- D 65 -
Short Seam Automat 2110-4 / 2111-4 Workinging Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.1 System menu
Creating seam program
1. Request free memory location:
• Press  key
The two numbers to the right of the M are highlighted in
black, the number description of the location can be en-
tered.
2. Enter two-digit number description (e.g. 20).
If the input cursor (black rectangle) is displayed without
further number description, the location is available.
If the sewing program is to consist of several seams, make
sure that the entire sequence of seam numbers is avai-
lable.
NOTE - Seam number
In the program control, a seam number can be allocated
only once. If a seam is to be reconfigured, make sure that
the seam number does not exist in other sewing programs
Setting the seam sequence:
The settings refer to the selected sewing program. The
sequence for sewing the seams can be set at will. When
the sequence is set, existing seam numbers are overwrit-
ten or new seam numbers are written.
• Press
key.
6
• Press  key.
The display shows the marking of the sewing program and
the seam numbers.
20 01 02 03 04
Mark seam number to be changed using cursor:
20 01 02 03 04
Open overwrite function:
• Press
% key.
Enter new seam number using numeric keypad:
20 01 04 03 04
Confirm input and exit menu:
• Press
 key.
The display shows the new seam sequence.
20 01 04 03 04