Beisler 2111-4 - Manual (Page 43)

- C 43 -
Short Seam Automat 2110-4 / 2111-4 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.5 Machine set-up
Rear stop point adjustment:
The rear stop point is adjusted correctly if the clear length
B of stop screw
2 at the pedestal is exactly 10 mm.
1. Fig. 12: Loosen lock nut
1 of stop screw 2 and ro-
tate stop screw to the desired position.
2. Check length B.
3. Tighten stop screw lock nut.
Adjustment of the clamp rail parallel orientation:
1. Check to see if the sewing head needle is positioned
exactly parallel to the clamp rail along the entire length
of the rail by moving the main clamp under the sewing
head and checking the distance between rail and need-
le at several locations.
2. Fig. 13: If distance is not identical at all locations, loosen
eight retaining screws
1 of clamp bracket and move
clamp rail to parallel position.
3. Tighten clamp bracket retaining screws and recheck
parallel orientation of clamp rail.
Fig. 12/13
Fig. 12
Fig. 13
1