BSS Audio FDS-388 OMNIDRIVE Owner's Manual - Manual (Page 23)

23
system designer. If the password is entered correctly, the middle
soft key will allow the user to enter the OEM Hide Screen. If the
password is incorrect, the Lock Mode returns to off. If the user
wishes to create a new program and lock areas using OEM hide
then they should begin by recalling the default program (program
0) or another program which is not OEM locked. All OEM pro-
grams are denoted on the Recall Screen with a diamond next to
their name. Programs which have not been used as OEM pro-
grams before (e.g. after recalling the default program) can be set
to OEM by entering the password 'BSS' when prompted. Refer to
Section 19.0, System Security.
OWNER OWNER mode allows the owner of the unit to program a system
and then lock the unit against being reset. With Owner lock ON,
files cannot be deleted, the default program cannot be recalled
and limiters cannot be adjusted. To enter Owner mode, turn the
encoder fully clockwise on the Owner Lock box. To change
Owner mode, the user must enter the current password. In a new
unit the password is 'OMNI'. If turning Owner mode ON, the
user can enter a new password once the old password has been
accepted. There is no way to turn Owner mode off if the pass-
word has been forgotten! Refer to Section 19.0, System Security.
Power Up Mute, 5s to 60s
This utility allows the user to adjust the time between powering up the unit and
the outputs being returned to the mute status that was set prior to the unit last
being switched off. If the value is set to Mute, the unit will always stay in mute
after powering up.
Audio In Anlg, AES
When an AES3 input/output board is fitted, this option selects between analog
input or AES3 input. Please refer to Appendix C.4.
Sample Rate 44.1, 48
When an AES3 input/output board is fitted, this option selects the sampling
frequency to be either 48kHz or 44.1kHz. Please refer to Appendix C.4.
Default Utility Screen
Middle Soft Key
OEM HIDE
OEM HIDE is only visible once a password has been entered after setting Lock
Mode to OEM. The OEM Hide screen allows system designers to lock details of
a system setup against being adjusted or viewed by unauthorised users. Refer
to Section 19.0, System Security.
MIDI DUMP is intended for use in transferring all the data from one FDS-388
to another. The sending FDS-388 should be connected to the receiving FDS-
388 with a midi cable. Press theTop Soft Key to initiate the transfer. The
receiving FDS-388 will display the question "Receive dump and overwrite all?"
Select YES on the receiving unit first. The sending FDS-388 will display the
question 'Chan n dump. Receiver ready?" where n is the current midi channel.
Select YES on the sending unit to start the dump. Top Soft Key
MIDI DUMP