BSS Audio FDS-388 OMNIDRIVE Owner's Manual - Manual (Page 30)

30
EQ Utility Screen
10.0 EQ Utility Screen
Filter Shape Low, Bell, High
Each of the available filters in each band can be selected to be low shelving,
bell or high shelving. This selection always applies to the currently selected
filter in the Eq Screen. The current band name and the band letter and filter
number are shown next to this variable for reference.
Filter Mode Norm, Phase
Filter Mode selects whether or not the user wishes to use one filter per band for
phase correction. With this value set to Normal, two filters are available for
equalisation in each band. With it set to Phase, one is stolen and used in the
Delay Screen to adjust the phase correction at each crossover point. Refer to
section 7.0, Delay Screen. Note that it is always filter 2 in each band that is
taken for phase adjustment. Each band is adjustable individually and it is the
current band's value of Phase/Normal that is adjusted here.
Dynamic Filter Off, A1, B1, C1, D1
This selection is used to select one filter per side to act dynamically; its cut or
boost are adjusted as the signal level in the band changes. Refer to Dynamic
Filter on the next page.
Dyn Thresh Adjustable -20dB to -2dB
The value determines the threshold below which the dynamic filter operates.
The value is in dB relative to the band limiter threshold. Refer to Dynamic
Filter on the next page.
Dyn Link On, Off
With Dynamic Link on, the control signals for the left and right dynamic filters
are combined to prevent differences between them causing stereo shifting
effects. With this value off, the two sides work independently. Refer to
Dynamic Filter on the next page.