BSS Audio FDS-388 OMNIDRIVE Owner's Manual - Manual (Page 8)

8
2.0 Installation
As part of BSS Audio Ltd’s policy of quality control, this product is carefully
checked before packing to ensure flawless appearance and that it reaches you
in first class condition.
After unpacking the unit, please inspect it for any physical damage. If any
damage has occurred, notify your dealer immediately. A written claim for
damages can then be initiated. The Warranty, Section 21.0, at the end of the
manual gives more information.
Please retain the shipping carton and all the packing materials for use should
the unit need to be transported or returned for any reason.
The FDS-388 requires a vertical rack space of 2U (3.5" 88mm). The unit should
be supported at its rear by additional bracing or shelving if it is to be used in a
transportable system. Failure to do so may damage the case and invalidate the
warranty. Fig 2.1 details the relevant dimensions and fixing centres for the
FDS-388.
Adequate ventilation must be provided by allowing sufficient space around the
sides and rear of the FDS-388 to ensure free circulation of air. Forced cooling
is not required. Note that the FDS-388 has a cooling fan mounted on the right
hand side of the case when viewed from the front.
Before connecting the FDS-388 to an AC power source, check that the voltage
selector switch on the rear panel is correctly set. If a change is necessary then
ensure that the mains fuse is changed for one of the correct current rating
2.1 Unpacking
Installation
Unpacking
Mechanical Requirements
Fig 2.1 Overall
dimensions of the
FDS-388 Omnidrive
2.2 Mechanical
Requirements