Auto switching, Auto switching -32, Figure 3-40 stdma/scpc auto switching screen – Comtech EF Data CDM-570/570L Vipersat User Manual
Page 68: Hub), Figure 3-41 stdma/scpc auto switching screen, Remote), Ither figure 3-40 (hub, M) or figure 3-41 (remo
Vipersat Configuration
3-32
Vipersat CDM-570/570L User Guide
Figure 3-40 STDMA/SCPC Auto Switching screen (Hub)
Load switching is controlled by both the Hub and the Remote, and thus related
commands appear in both screens. The initial Load switch request is made by
the Hub. Once in SCPC mode, subsequent Load switch requests (Step Up, Step
Down) are made by the Remote.
Application switching, ToS switching, and QoS switching are controlled by the
Remote, and thus appear only in the Remote Auto Switching screen.
Figure 3-41 STDMA/SCPC Auto Switching screen (Remote)
Auto Switching
The Auto Switching item is for information only and shows the current config-
uration of this feature for the target CDM-570/570L. This feature is Enabled and
Disabled as described in the section “Feature Configuration” on page 3-5. Auto
Switching must be Enabled in order to utilize any of the related features/
commands in this menu.