ConnectGear GP-10P - Manual (Page 40)

User's Manual
‰ Better printing performance.
‰ The Advantage of a Remote Printer
‰ Save user licenses.
NOTE: This remote printer feature is not available for the
10/100Mbps 3-port PrintSir models.
5.2 NetWare 3.x Installation & Setup
Once your PrintSir is connected to your Ethernet network, you can set
it up for use with your networking software. There are two methods you
can use to do this easily:
P l e a s e n o t e t h a t , y o u n e e d i n s t a l l t h e I P X p r o t o c o l b e f o r e t h e
following procedure,
1. On DOS environment or DOS box of Windows, use the “INSTALL”
quick-installation program found on the <CD-ROM Drive>\DOSUTIL
of CD-ROM included with the PrintSir.
2. On DOS environment or DOS box of Windows, use the “PSETUP”
c o n f i g u r a t i o n p r o g r a m f o u n d o n t h e i n c l u d e d < C D - R O M
Drive>\DOSUTIL, configure the PrintSir to use a particular file server.
Then, use NetWare’s PCONSOLE program to create a NetWare print
server and print queue with the appropriate names.
5.2.1 Quick Installation Using “Install” program
The INSTALL program included on the CD-ROM can be used to
quickly set up the PrintSir for use on the NetWare environment. It can
only be used to set up the PrintSir as Printer Server mode; it cannot be
used to configure the PrintSir as Remote Printer mode. It handles changing
the PrintSir’s internal settings, the creation of NetWare print server and
print queue objects on the file server, and the assignment of the print
server to the queue. Unless you need to configure the NetWare settings to
conform to special requirements for your network, you can use the quick
installation method.