Cybex 5000 Series PL - Manual (Page 116)

Maintenance
Page 6-4
Attachment Hole
NOTE: Replace bar if
less than 1/8” of material
remains to the edge.
Figure 5
3. Inspect bars and handles for wear, paying particular attention to tab area connecting points.
Replace all worn handles immediately.
! CAUTION: Replace all worn handles immediately. Do not use if less than 1/8” of
material remains to the edge. See Figure 5.
4. Inspect snap links for proper latching (indicates wear). Replace all worn snap links
immediately.
5. Inspect all labeling for readability. This includes instructional placards, warning and caution
decals. Replace all warning labeling immediately.
6. Inspect all weight stacks for proper alignment and operation.
NOTE: Correct all improper alignment and operation issues immediately.
7. Wipe Weight Stack Guide Rods and Leg Press Linear bearings clean over entire length.
Lubricate with a light coat of medium weight automotive engine oil.
Cybex Plate Loaded Owner’s Manual