Cybex 5000 Series PL - Manual (Page 33)

Cybex Plate Loaded Owner’s Manual
2 - Technical Specifications
General Specifications
Frame Finish
• Shall be made of mechanical quality 11 gauge and 16 gauge steel purchased in mill run
quantities to assure the best consistency.
• Prior to applying finish, each part shall be put through a multi-stage wash to remove all
oils and to chemically prepare the surface for maximum adhesion. After the wash, the
frames shall be dried and coated with an Electrostatically applied powdercoat finish that
shall be applied in powder form and then baked until cured.
• The finish shall be textured and very hard, assuring a scratch and chip resistant finish.
Pulleys
• Shall use Dupont Corp. fiberglass-reinforced nylon 70G33 material, tensile strength rated
at 22,500 PSI with 6203ZZ double sealed bearings dynamic load rated at 1600 lbs.
• Pulleys shall be 4.50 inches in diameter with a cable groove with a depth of .250 inches.
Counter Balanced Input Arms
• Input arms on equipment shall be counter balanced where appropriate to eliminate the
weight of the assembly from the weight selected by the user.
Handgrips
• Plated Loaded machines shall use closed-end PVC closed cell foam vinyl sleeve.
• Select Plate Loaded machines shall use either “Grabbaroo” thermoplastic rubber extruded
grip material that is non-absorbing, wear and tear resistant and exhibits good wet and dry
friction characteristics.
• Diameter should be 1 3/8” to increase comfort through reduced pressure.
Technical
Specifications
Page 2-1