Microcom 322M User Manual
Page 109
Appendix C
Quick Reference Command Summary
322M Operator’s Manual
105
^A
^D
COMMAND
XX
92
Load Value for Slices to Process: This command adjusts the number of
slices (dot rows) generated before the motor drive starts moving. The default
is set to a value of 256 and has a range of 1 to 366.
X
93
Load Control Code Recognition Status:
0
Enable control code recognition
1
Disable control code recognition
XX
95
Load Advance/Retract Distance: Used in conjunction with cutter and
dispense command. The ^Axx specifies the amount to advance after printing
and then retract to dot row.
XX
96
Load Advance Delay: The ^Axx specifies the amount of delay, in
milliseconds, the printer waits before retracting to dot row in cutter and
dispense modes.
X
97
Tag/Tear Dispense Mode
0
Disables Tag/Tear Mode
1
Advance after every label.
2
Advance after copies count.
3
Advance when idle.
X
98
Peel-n-Dispense Mode
0
Disable Peel-n-Dispense
1
Enable Peel-n-Dispense
2
Enable Custom Applicator Mode (Peel-n-Dispense with no delay)
X
99
Cutter Control: This command will enable full and/or partial cuts. Commands
102 and 103 can be used to set the cut intervals. Partial cuts are only
available on printers that have a partial/full cutter installed. If this command is
set to a value of 2 (Partial Cut), the printer will pause until the label is removed
before retracting and printing again.
0
Disable Cutter Control
1
Enable Full Cut
2
Enable Partial Cut
3
Enable Full and Partial Cut
100
Clear User RAM: This command clears all downloaded font, graphics and
stored format files.
101
Send User RAM Available: The printer will send the number of free or
available bytes to the serial port (i.e. >192480<).
XX
102
Full Cut Interval: Instructs the printer when to issue a Full Cut. The default
value is 1. If it is set to a value of “1” the printer will full cut whenever the
copies count has been reached or after each format if a copies count has not
been specified. If this command is set higher than “1” (maximum of 65536),
the printer will full cut when that quantity has been reached. This command
will not operate if the Cutter Control (^D99) command is set to full cut.