Microcom 322M - Manual (Page 22)

Getting Started Chapter 3
18
322M Operator’s Manual
3.4.1 Print Button
Operation Description
Printing a label
Press the print button while the printer is idle or paused will
reprint the last label or after a cold start, a power up label will
print.
Printer Pause
Press the print button while the printer is printing will cause the
printer to enter the paused mode.
Note: Press the print button again to continue printing.
Feeding Labels
Hold the print button down while the printer is idle to feed labels.
The printer will continue feeding labels until the button is
released.
Table 5 Print Button Description
3.4.2 Status Indicator Light
Light Color Description
Solid Green.
Indicates that the power is on and the printer is in a ready state.
Solid Red.
Indicates an error has occurred. The printer will remain in this
state until the condition is removed. If an unexplained error
persists, contact your Service Representative.
Note: Refer to Chapter 11: Troubleshooting for helpful hints.
Solid Amber.
Indicates that the printer has been paused, or a tag/tear mode
has been enabled.
Flashing Red.
LED Flashes Red during a download indicates that the memory
operation was not successful.
Power Spike or low voltage on the AC line. The unit will remain
in this mode until the condition is removed and the printer power
is cycled.
Table 6 Status Indicator Light Description