Microcom 322M - Manual (Page 93)

322M Operator’s Manual
89
Chapter 10: Printer Maintenance
10.1 Maintenance Schedule
It is important to note that the optimum print quality and print head life is achieved by
maintaining a clean printer and print head. A Microcom Corporation approved cleaning kit
(part # 040005-0000) is available; contact your sales representative for purchasing
information.
AREA METHOD INTERVAL
Print head
Foam tipped swab, cotton tipped
swab, or thermal printer cleaning
card dampened with Isopropyl
Alcohol.
See section 10.4
After every roll of
media or every 512
feet of tag stock or
fanfold media.
Drive Roller
Foam tipped swab, cotton tipped
swab, thermal printer cleaning
card, or lint-free cloth dampened
with Isopropyl Alcohol
See Section 10.5
After every roll of
media or every 512
feet of tag stock or
fanfold media.
Peel Edge
Foam tipped swab, cotton tipped
swab, thermal printer cleaning
card, or lint-free cloth dampened
with Isopropyl Alcohol
See section 10.3
As Needed.
Interior Cleaning
Compressed air, soft-bristle
brush, and/or lint-free cloth
dampened with Isopropyl Alcohol.
See section 10.3
As Needed.
Exterior Cleaning
Lint-free cloth dampened with a
mild, non-abrasive general
purpose cleaner.
See section 10.6
As Needed.
Table 20 Recommended Maintenance Schedule
CAUTION: Microcom Corporation will not be held responsible for
damage caused by any non-approved solvent, cleaning material and/or
method. The use of such non-approved materials and/or methods may
void appropriate expressed or implied warranties.