ONICON System-10 BTU - Manual (Page 42)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
System-10 BTU Meter Manual 03/15 - 0651-16 / 18323 Page A-8
Step 4:
Connect field wires from the System-10 BTU meter
to the transmitter as shown. Carefully coil extra wire
around the transmitter and thread the lid onto the
connection head.
REFERENCE
SIGNAL
Step 3:
Place the transmitter over the retainer nut, gently
guiding the excess wire through the center hole of the
transmitter. Use caution to avoid pinching the wires.
Customer
provided tee.
The thermowell, extension nipple, coupling and fitting were made to a
specific length. DO NOT attempt to change the length of this assembly.
NOTE: In 1” pipe, thermowell must be installed in a customer provided tee as shown below.
TO BTU METER
RED WHITE