ONICON System-10 P1 - Manual (Page 3)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 3
TABLE OF CONTENTS
1.0 INTRODUCTION ..................................................................................................5
1.1 PURPOSE OF THIS GUIDE ...................................................................... 5
1.2 TYPICAL SYSTEM-10 BTU METER ........................................................5
1.3 STANDARD FEATURES AND SPECIFICATIONS ................................... 5
1.4 ADDITIONAL REQUIRED HARDWARE ..................................................7
1.5 WORKING ENVIRONMENT ....................................................................7
1.6 WARRANTY AND SERIAL NUMBER .....................................................7
2.0 UNPACKING .....................................................................................................8
2.1 CHECKING THAT YOU HAVE RECEIVED EVERYTHING ..................... 8
3.0 INSTALLATION ....................................................................................................9
3.1 SITE SELECTION ......................................................................................9
3.2 MECHANICAL INSTALLATION ............................................................10
3.2.1 Main Unit Installation ...............................................................10
3.2.2 Thermowell Installation ...........................................................11
3.2.2.1 Standard Thermowells ..................................................11
3.2.2.2 Hot Tap Thermowells ....................................................11
3.2.3 Temperature Sensor Installation ..............................................13
3.2.4 Flow Meter Installation ............................................................ 14
3.3 ELECTRICAL INSTALLATION .........................................................................15
3.3.1 Input Power ...............................................................................15
3.3.2 Input Signal Connections ..........................................................18
3.3.2.1 Input Signal Connections from Temperature Sensors..18
3.3.2.2 Input Signal Connections from Insertion Turbine........19
3.3.2.3 Input Signal Connections from F-2500 Meters .............19
3.3.2.4 Input Signal Connections from F-2600 & F-2700 .........20
3.3.2.5 Input Signal Connections from F-3100 & F-3200 .........20
3.3.2.6 Input Signal Connections from F-3500 Meters .............21
3.3.2.7 Input Signal Connections from FB-3500 Meters ..........21
3.3.2.8 Input Signal Connections from F-4200 Meters .............22
3.3.3 Contact Closure Output for Energy Total(s) and Mode ...........23
3.3.4 Isolated Analog Output(s) .........................................................24
3.3.5 Network Signal Connections ....................................................25
3.3.6 Optional Isolated Digital Pulse Input (Di3) .............................26
4.0 SYSTEM-10 START-UP AND COMMISSIONING ............................................29
4.1 DISPLAY AND KEYPAD OPERATION ...................................................29
4.2 PROCESSOR START-UP .........................................................................29
4.3 UNITS AND MULTIPLIERS ....................................................................30
4.4 ANALOG OUTPUTS ...............................................................................30
4.5 ENTERING A NETWORK ADDRESS, SELECTING THE FLOW METER
LOCATION & ENABLING / DISABLING FRONT PANEL RESET .........31
4.5.1 Application Number ....................................................................32
4.6 SYSTEM-10-P1 POINT DATABASE .......................................................33
4.6.1 System-10-P1 Point Database .........................................................33
4.7 COMMISSIONING ...................................................................................35