Research Concepts RC4000 - Manual (Page 117)

RC4000 Antenna Controller Chapter 4 Support
109
4.0 SUPPORT
4.1 Installation
Proper installation is important if the full capability and accuracy of the RC4000 is to be realized. The
procedures that follow will insure the optimum level of performance from all sensors and the system in
general.
Installation will be more efficient if each step in the physical installation and calibration be performed in
the order in which it appears in the following schedule. Each step is referenced to a particular section of
this manual, and should be checked off as it is completed. Coordination between the mount
manufacturer, vehicle integrator and end user is required. Some steps are applicable only if the tracking
or remote control options were purchased with the unit. The installation procedures are written to cover
the most common mount installations. Some steps are slightly different according to the type of mount
the RC4000 is interfacing to (see appendix B). Installation requires basic operational knowledge of the
RC4000. Please review chapter 3 for information on how to navigate the RC4000’s screens and how to
enter data.
SECTION ACTION COMPLETE
2.3 Initial Configuration
2.3.1 Software Initialization
2.3.2 Elevation Calibration
2.3.3 Azimuth Calibration
2.3.4 Polarization Calibration
2.3.5 Fast/Slow Motor Speed
2.3.6 Pulse Sensor Checkout
2.3.7 Drive System Checkout
2.3.8 Navigation Sensor Communication
2.4 Final Calibration
2.4.1 Compass Calibration
2.4.2 Azimuth and Elevation Alignment
2.4.3 Signal Strength Adjustment
2.4.4 Pulse Scale Factors
2.4.5 Miscellaneous Adjustments
2.4.6 Mechanizing Automatic Locate
********************************
Whereas Final Calibration (section 2.4) requires an open area with an unobstructed view of satellites,
initial configuration may be done in any area (possibly a shop environment) where the antenna may be
moved throughout its entire range of travel.
At this point, the installer will have to start operating the RC4000 from the front panel. Section 3 will need
to be reviewed to perform the steps described below.