Super Systems MGA6000 - Manual (Page 8)

SSi Manual #4563 Rev. D Page 8 Multi-Gas Model 6000
Menu List
The menu list shows the available pages, displayed six at a time. To access the list, press the Esc key.
Depending upon where the user is starting from, it may require pressing this button more than once. The
up (Ï) and down (Ð) arrows are used to scroll through the selections, which are repeated below. To go to
a specific page, either type in the page number and press Enter, or use the arrow keys to highlight the
selection and then press Enter.
Operator Level – No Pass Code Required
1. MAIN PAGE
2. IR STATUS (Availability depends on configuration)
3. GENERAL INFORMATION
4. PUMP CONTROL
5. SET DISPLAY VALUES
6.
[NOT CURRENTLY USED]
7. CALIBRATION DATES
8.
[NOT CURRENTLY USED]
9. [NOT CURRENTLY USED]
10. ABOUT / SIGN-ON
11. REVISION DISPLAY
12.
[NOT CURRENTLY USED]
13. [NOT CURRENTLY USED]
14. [NOT CURRENTLY USED]
15. [NOT CURRENTLY USED]
Supervisor Level – Level 1 Pass Code Required
16. SET THE DATE AND TIME
17. SAMPLING PARAMETERS
18. IR CELL ZERO CALIBRATION
19. 4 – 20 mA OUTPUT ASSIGNMENT
20. AUTO CALIBRATION SETUP
21. MAIN DISPLAY SETUP
Configuration Level – Level 2 Pass Code Required
22. COMMUNICATIONS SETUP
23. CALCULATION FACTORS
24. IR CELL SPAN CALIBRATION
25. SET PASS CODES
26. SET IP ADDRESS
27. H2 CELL CALIBRATION (Availability depends on configuration)
28. AUTO SEQUENCE SETUP
29. GAS or CV CONFIGURATION
Menu options 6, 8, 9, 12, 13, 14, and 15 are reserved for future use and are not currently used. To minimize the
possibility of unintended modifications to the instrument, certain menu pages will require the entry of a pass code to
access them. Pages 1 through 15 are Operator level screens that do not require any security codes. Pages 16 - 21 are
Supervisor screens requiring a level 1 pass code (default = 1). Pages 22 – 28 are Configuration screens requiring a