SVSi N2000 Series - Manual (Page 18)

Page 18 N2000 Series User Manual www.svsiav.com
Chapter 2. Installation Rack Mounting Options
Rack Mounting Options
N2000 Series Stand-Alone Units
A Rack Shelf (SVSi part number N9102) accommodates up to two stand-alone N-Series
Encoders or Decoders, side by side (mix and match).
Figure 2-2. Rack Mounting Stand-Alone Units
N2000 Series Cards
A Card Cage (SVSi part number N9206) accommodates up to six N-Series Encoder/Decoder
cards (mix and match). The 12V power supply of the N9206 is the primary power source for the
installed cards. If the 12V power supply fails or is unplugged, the cards will power down, detect
PoE (if provided by switch) and restart normally using PoE. This usually results in a power loss of
about one to two seconds. The unit then reboots (which takes another one to two minutes).
To rack mount N2000 Series cards into the N9206 Card Cage, follow these steps:
1. Gently slide the card into cage slot. Make sure the card is properly aligned with guides. The
card’s front LED indicators should align with holes in the cage’s faceplate. See Figure 2-3 .
Figure 2-3. Rack Mounting Cards