SVSi N2000 Series - Manual (Page 31)

Page 31 N2000 Series User Manual www.svsiav.com
Chapter 2. Installation Changing IP Addresses
STEP 5 CONNECTING ENCODERS TO AN INPUT SOURCE
Having already connected the Encoder(s) to the network and made the appropriate settings changes (as
described in
Step 3 and Step 4 ), you can now connect to the appropriate AV source(s).This connection from
an Encoder DVI-I port (female) to an input source is accomplished using either a DVI-I cable or HDMI
(through adapter).
1. Connect the source you would like to use for the Encoder (camera, laptop, etc.) to the
Encoder’s DVI-I Input port using a DVI-I cable (or HDMI through adapter). This connection
can be digital or analog.
2. Repeat until all Encoders are connected to their sources.
Figure 2-11. Encoder Connection to Source
N2000 Encoder
PoE-Enabled Switch
Network
DVI-I Cable (or HDMI through adapter)
Cat-5 Cable