ACTi ENR-1000 - Manual (Page 131)

www.acti.com
ENR-
1000 Series System Administrator’s Manual
131
Disk Management
ENR keeps the recordings on SATA hard disks installed in it. Whenever recording is taking
place, ENR writes data to one of the disks, and switch to the other as the original one is full.
Once the available space of the whole system is less than the reserved size, ENR will start
deleting the oldest file to make the amount of space allowing each active channel to record
for another 10 minutes.
You may observe the disk memory and recording status on Storage page.
Go to Setup page  System tab  Storage . The connected storage devices will be shown
in the Storage Device list.
Format Hard Disks
Select a disk and click “ Format ”.
You may execute disk formatting toward a newly-installed disk. You should follow the
installation procedures (refer to Install the Hard Disks on page 22 ) to format the disks before
ENR system start carrying out the surveillance task, for a disk that is not in ENR file system
format is not ready for recording. Please note that the system will stop recording during the
disk formation.
If you have to format a disk having been recording for a while, it is suggested that you export
important video and system log in advance.