ACTi ENR-1000 - Manual (Page 55)

www.acti.com
ENR-
1000 Series System Administrator’s Manual
55
Enable DHCP Server
You may enable the built-in DHCP server for either LAN1 or LAN2 port.
Go to Setup page  Network tab  click “ DHCP Server ”:
1. Check “ Enable ” and select a LAN, this LAN has to be in Manual mode.
2. Set the Beginning IP Address and Ending Address , and click “ Save ”. ENR will assign
IP addresses within this range to the cameras connected to the selected LAN port. Please
(1) make sure the cameras are in DHCP client mode, (2) connect and power the cameras up
after you enable this service.