ACTi ENR-1000 - Manual (Page 44)

www.acti.com
ENR-
1000 Series System Administrator’s Manual
44
(B) Motion Settings
After selecting the camera, click “ Motion Detection Settings ”. If this camera is in dual
stream mode, only Channel ID 1 (Stream 1) supports motion detection feature. On Motion
Detection Settings window, check “ Enable ” then click “ Motion Setup ”. To enable one
motion region, check it, a color frame will appear in the view. You may start setting the
detection area by adjusting this yellow frame on the view. Simply use your mouse to move
and resize the frame. Click “ Apply ” to save the settings.
Field Name Description
Sensitivity
(0-100%)
Determines how sensitive the camera reacts to the movement. The higher the
sensitivity level is, the smaller motion will trigger the alarm, but may give false
alarms. Default is 70%.
Timer
(0-300 secs)
The interval before the next motion detection can be triggered again.
Default is 1 second.
Threshold
(0-100%)
The threshold level of this motion detection region. The lower threshold level
is, smaller portion of the region would be considered as motions, which is
more easily to be triggered, but may give more false alarms.
Default is 10%.
To move the entire frame
Place the mouse cursor over the
title bar , and drag to move.
To adjust the region dimension
Place the mouse cursor over the
bottom right corner , and drag to
resize.
To disable this
detection region
Place the mouse cursor
over the
upper right
corner , and click the “ x ”
to close this frame.
1
2
3