ACTi ENR-1000 - Manual (Page 43)

www.acti.com
ENR-
1000 Series System Administrator’s Manual
43
Change Camera Settings
After the cameras are added, you may change their properties on Camera tab.
(A) Video format and transmission properties
(B) Video adjustment
(C) Motion Detection settings
(D) PTZ settings
(A) Video Format and Transmission Properties
To modify the video format and transmission properties including Channel ID , Resolution ,
Frame Rate , Protocol , and Bitrate , you will have to click
first to sync with the camera first. After configuration, click “ Save ” to save this setting to
camera
A
V
B
V
C
V
Note
1. Changing the video resolution will reset your current motion region settings. Please
re-configure the settings later.
2. For local display viewing, please DO NOT (1) change the video resolution to higher
than 2M pixels or (2) change the video codec to MJPEG or MPEG4, for these types of
video streams are only displayable through ENR web interface.
D
V