Emerson Process Management OXYMITTER 4000 - Manual (Page 29)

Instruction Manual
IB-106-340C Rev. 4.1
July 2004
Rosemount Analytical Inc. A Division of Emerson Process Management P-21
Hazardous Area Oxymitter 4000
Insulation surface should be lightly sprayed with water before removal to suppress airborne dust. As water evapo-
rates during removal, additional water should be sprayed on surfaces as needed. Only enough water should be
sprayed to suppress dust so that water does not run onto the floor of the work area. To aid the wetting process, a sur-
factant can be used.
After RCF removal is completed, dust-suppressing cleaning methods, such as wet sweeping or vacuuming, should
be used to clean the work area. If dry vacuuming is used, the vacuum must be equipped with HEPA filter. Air
blowing or dry sweeping should not be used. Dust-suppressing components can be used to clean up light dust.
Product packaging may contain product residue. Do not reuse except to reship or return Ceramic Fiber products to
the factory.