Emerson Process Management OXYMITTER 4000 - Manual (Page 54)

Instruction Manual
IB-106-340C Rev. 4.1
July 2004
2-8 Installation Rosemount Analytical Inc. A Division of Emerson Process Management
Hazardous Area Oxymitter 4000
P S U
E
I T
P
I C
R
H W
E N
T H G
C
KE
N I -
E
E R
W A V I
S O L P -
X
O M T A G NI
N
-
R
I
T
L A
I
VE -
E E H
GAS CAL.
DRIP
LOOP
LOGIC I/O,
4-20 mA SIGNAL LINE
VOLTAGE
REPLACE INSULATION
AFTER INSTALLING
HAZARDOUS AREA
OXYMITTER 4000
INSULATION
MOUNTING
PLATE
STACK OR DUCT
METAL WALL
26310010
Figure 2-7. Installation with Drip Loop and Insulation Removal
c. Remote Electronics Installation
For a Hazardous Area Oxymitter 4000 with
the remote electronics option, install the
probe according to the instructions in para-
graph 2-1.b. Install the remote electronics
unit on a wall, stand pipe, or similar struc-
ture (Figure 2-2 and Figure 2-8).
37260016
Figure 2-8. Remote Electronics Mounting
2-2 ELECTRICAL INSTALLATION (FOR
HAZARDOUS AREA OXYMITTER 4000
WITH INTEGRAL ELECTRONICS)
All wiring must conform to local and national
codes.
Disconnect and lock out power before
connecting the unit to the power
supply.
Install all protective equipment covers
and safety ground leads after installa-
tion. Failure to install covers and
ground leads could result in serious
injury or death.