8 setting up using cli, 1 connection via terminal, Setting up using cli – ATL Telecom AM200 User Manual
Page 34: Connection via terminal port, 8setting up using cli
ATL User Guide
AM200 Modem
34
8
SETTING UP USING CLI
The AM200 can be set-up and controlled via the Command Line Interface (CLI) mode. The CLI mode is
accessed via a VT100 Terminal or PC connected to the Terminal port, or via a PC connected to the Ethernet
port.
The PC needs to be running the TeraTerm VT100 emulation program. This program can be down loaded from
the ATL website http://www.atltelecom.com/support/.
8.1
CONNECTION VIA TERMINAL PORT
Connect a VT100 terminal (or PC running TeraTerm VT100 emulation program) to the 9-way Terminal serial
port on the front of the unit. Configure the serial port settings of the VT100 terminal to 19,200 baud, 8 bits,
no parity, 1 stop bit and Xon/Xoff.
The log on prompt will appear once the AM200 has completed it’s power-on sequence. If the Logon prompt
does not appear, press the 'return' key and the Logon prompt will appear. Type in the default login name
'admin'
The Password: prompt will then appear on the screen. Type in the default password 'admin'.
The
→
→
prompt should then be shown on the screen with a successful login. You are now ready to configure
the AM200 using CLI commands.