ATL Telecom AM200 - Manual (Page 35)

ATL User Guide
AM200 Modem
35
8
8.2 CONNECTION VIA ETHERNET PORT - TELNET
Connect an Ethernet cable from the Ethernet network to the Ethernet port on the rear of the unit. Start the
TeraTerm software package. From the Menu bar select File, then select New Connection from the drop-down
menu.
Select the TCP/IP option and type in the default IP address for the AM200. The default IP address is
10.254.254.253.
Click on the OK button to save the connection.
After a few seconds you should then see the ATL Telecom Login: prompt on the screen. Type in the default
login name 'admin' (Note in the following examples the IP address of the AM200 was set to 10.10.15.6,
however you should use the correct IP address set for your AM200 unit)
The Password: prompt will then appear on the screen. Type in the default password 'admin'.
The → → prompt should then be shown on the screen with a successful login. You are now ready to configure
the AM200 using CLI commands.