ATL Telecom AM200 - Manual (Page 77)

ATL User Guide
AM200 Modem
77
9
9.3.6.6 DEVICE
The Device screen (Figure 47) allows the user to set the AM200 dsl mode as either CO or CPE.plus the user
can select the required line rate from the Line Rate drop-down menu. The DSL line can also be enabled or
disabled by selecting the required option from Enable Line drop-down menu.
The Management Mode option allows you to set the management mode as either a Slave, Master or
Independent. Setting the management mode to Master (Figure 48) will allow you to configure the remote
slave unit. The remote configuration options are displayed once the master mode has been selected and the
applied button has been selected. The model shown in the Expected Model Type option must match the
remote model type.
For LCD variants the user can also enable or disable the LCD and set the LCD timeout (in minutes).
Figure 47 Device Configuration screen