ATL Telecom AM200 - Manual (Page 38)

ATL User Guide
AM200 Modem 38
8.4 CLI HELP COMMAND
By using the ? character when entering commands into the CLI, the User can receive help information on how
to complete their command. Using the ? character will tell the CLI to list all the possible entries that can come
next.
The following example illustrates the way the ? character is used to help the user complete their command.
In the example the line rate will be set to 2048K. Lines preceded with --> represents input from the user, lines
not preceded with anything represent the response from the CLI.
Type in :-
--> ??
The CLI will respond with :-
cconsole For debug use only
source Read a file of commands
help
ethernet Ethernet transport manipulation
system System-level commands
user
imdebug For debug use only
transports Bearer channels in use
ip Configure IP router
igmp
debcli For debug use only
eeprom For debug use only
inventory Configure and view generic information
hdlc Configure and view status of your hdlc interfaces (ethernet)
nx64 Configure and view status of your nx64 interfaces
ds0 Configure and view status of your ds0 interfaces (rfc2494)
ds1 Configure and view status of your ds1 interfaces (rfc2495)
am200 Configure and view status of your am200
pppoa
pppoe
pppoh
bridge Configure layer 2 bridge
dhcpclient
dhcpserver DHCP server configuration commands
dhcprelay
dnsrelay
dnsclient