Interface specifications, Interface cables – H3C Technologies H3C SR6600-X User Manual
Page 14
6
Interface specifications
Table 6 Interface specifications
Item Specification
Connector type
SFP
Number of interfaces
•
HIM-4GBP: 4
•
HIM-8GBP: 8
Interface standards
802.3, 802.3u, 802.3ab
Supported frame
format
•
Ethernet_II
•
Ethernet_SNAP
Transmis
sion
power
Type Short
distance
Medium
distance
Long distance Long distance
Ultra-long
distance
Min.
–9.5 dBm
–9 dBm
–2 dBm
–4 dBm
–4 dBm
Max.
0 dBm
–3 dBm
5 dBm
1 dBm
2 dBm
Receiving sensitivity
–17 dBm
–20 dBm
–23 dBm
–21 dBm
–22 dBm
Central wavelength
850 nm
1310 nm
1310 nm
1550 nm
1550 nm
Fiber type
62.5/125 μm
multi-mode
fiber
9/125 μm
single-mode
fiber
9/125 μm
single-mode
fiber
9/125 μm
single-mode
fiber
9/125 μm
single-mode
fiber
Max. transmission
distance
0.55 km
(0.3418 miles)
10 km (6.21
miles)
40 km (24.86
miles)
40 km (24.86
miles)
70 km (43.50
miles)
Interface speed
•
1000 Mbps (recommended)
•
Full duplex
The following transceiver modules are available for the HIM-4GBP/HIM-8GBP:
•
100 Mbps fiber SFP transceiver modules.
•
1000 Mbps fiber SFP transceiver modules.
•
100/1000 Mbps fiber SFP transceiver modules.
•
10/100/1000 Mbps copper SFP transceiver modules (support for 10/100/1000 Mbps
autosensing on the HIM-4GBP/HIM-8GBP).
Prepare the transceiver modules yourself as required.
H3C recommends that you use H3C SFP transceiver modules for the device. H3C does not guarantee the
compatibility of SFP transceiver modules from other vendors with the device. The device reports an alarm
when non-H3C SFP transceiver modules are installed.
Interface cables
Use interface cables for the HIM-4GBP/HIM-8GBP as follows:
•
Fiber SFP transceiver module—Fibers with the LC connector.
•
Copper SFP transceiver module—Category-5 straight-through or crossover twisted pair cable when
the port is operating at 10/100 Mbps and Category-6 twisted pair cable when the port is
operating at 1000 Mbps.
For the appearance and connection of a HIM-4GBP/HIM-8GBP interface cable, see "