H3C Technologies H3C SR6600-X - Manual (Page 53)

45
Item Specification
Max power consumption
• Tested—125 W
• Theoretical—150 W
NOTE:
The theoretical max power consumption, greater than the tested max power consumption, is the upper
power consumption threshold defined for the SAP to prevent power module overloading. You must use the
theoretical max power consumption, rather than the tested max power consumption, to calculate the total
power consumption for managing power modules and determining power module numbers.
LEDs
Table 50 LED description
LED Status Description
RUN
(Green)
Off No power input is available or the SAP-24GBP has failed.
Slow flashing (1 Hz) The SAP-24GBP is operating correctly.
Fast flashing (8 Hz)
System software image is being loaded (in this case, never power
off the device or hot-swap the SAP-24GBP; otherwise, the
SAP-24GBP might be damaged).
SFP 0 to SFP 23
(Yellow/green)
Off No link is present or the cable is faulty.
Steady green A 1000 Mbps link is present
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 100 Mbps.
Interface specifications
Table 51 Interface specifications
Item Specification
Connector type SFP
Number of interfaces 24
Interface standards 802.3, 802.3u, and 802.3ab
Supported frame
format
• Ethernet_II
• Ethernet_SNAP
Optical
transmit
power
Type Short distance
Medium
distance
Long distance Long distance
Ultra-long
distance
Min. –9.5 dBm –9 dBm –2 dBm –4 dBm –4 dBm
Max. 0 dBm –3 dBm 5 dBm 1 dBm 2 dBm
Receiving sensitivity –17 dBm –20 dBm –23 dBm –21 dBm –22 dBm
Central wavelength 850 nm 1310 nm 1310 nm 1550 nm 1550 nm