H3C Technologies H3C SR6600-X - Manual (Page 21)

13
HIM-MSP2P (RT-HIM-MSP2P-H3)/HIM-MSP4P
(RT-HIM-MSP4P-H3)
The HIM-MSP2P/HIM-MSP4P is a high-speed OC-3/STM-1 (155 Mbps) and OC-12/STM-4 (622 Mbps)
non-channelized POS interface module. The HIM-MSP2P/HIM-MSP4P supports PPP, Frame Relay, and
HDLC at the data link layer and IP at the network layer.
When using the HIM-MSP2P/HIM-MSP4P, follow these guidelines:
• You can use the card-mode command to configure the interface module to operate in OC-3/STM-1
POS or OC-12/STM-4 POS mode.
• The configuration of the operating mode can take effect only after you hot-swap the interface
module or reboot the device. It is recommended to remove and insert the module to bring the
configuration into effect.
• The configuration of the operating mode takes effect for all the interfaces on the interface module.
• The interface module supports multi-mode short distance (1310 nm), single-mode medium distance
(1310 nm), single-mode long distance (1310 nm), and single-mode ultra-long distance (1550 nm)
transceiver modules.
NOTE:
The HIM-MSP2P/HIM-MSP4P is an optional interface module to be separately ordered if needed.
Front panels
Figure 11 Front panel of HIM-MSP2P
(1) Captive screw (2) Ejector lever
(3) SFP port carrier signal LED (LINK/ACT) (4) SFP port loopback/alarm LED (LP/AL)
(5) SFP port 1 (155 Mbps)/SFP port 0 (622 Mbps)
(6) SFP port 0 (155 Mbps)