H3C Technologies H3C SR6600-X - Manual (Page 37)

29
Item Specification
Central wavelength 850 nm 1310 nm 1310 nm 1550 nm 1550 nm
Max. transmission
distance 0.55 km (0.34
miles) 10 km (6.21
miles) 40 km
(24.86 miles) 40 km (24.86
miles) 70 km
(43.50 miles)
Fiber type
62.5/125 μm
multi-mode 9/125 μm
single-mode 9/125 μm
single-mode 9/125 μm
single-mode 9/125 μm
single-mode
Transmission rate 1000 Mbps, full duplex
The following transceiver modules are available for the HIM-16GBP interface module:
• 100 Mbps fiber SFP transceiver modules.
• 1000 Mbps fiber SFP transceiver modules.
• 1000/100 Mbps fiber SFP transceiver modules.
• 10/100/1000 Mbps copper SFP transceiver modules (10/100/1000 Mbps autosensing is
supported when the HIM-16GBP interface module uses this type of transceiver module.)
Prepare the transceiver modules yourself as required.
NOTE:
Use only H3C transceiver modules for the router. Transceiver modules from other vendors might be
incompatible with the router. The router reports an alarm when a non-H3C transceiver module is installed.
s
Interface cables
Use interface cables for the HIM-16GBP transceiver module as follows:
• Fiber SFP transceiver module—Fiber that uses an LC connector.
• Copper SFP transceiver module—Category-5 straight-through or crossover twisted pair cable when
the port is operating at 10/100 Mbps and Category-6 twisted pair cable when the port is
operating at 1000 Mbps.
For the appearance and connection of the interface cables, see " Connecting an Ethernet interface
cable " and " Connecting an optical interface cable ."
HIM-2EXP
The HIM-2EXP 10-GE interface module provides two SFP+ ports. It is half the height of a typical HIM, and
occupies one slot on a FIP.
Front panel
Figure 21 Front panel
(1) Captive screw (2) Ejector lever