H3C Technologies H3C SR6600-X - Manual (Page 64)

56
Item Specification
Combo interfaces
12.
• Copper port—Straight-through/crossover autosensing:
{
10/100 Mbps, half/full-duplex.
{
1000 Mbps, full-duplex.
• Fiber port—1000 Mbps, full-duplex.
Hot swapping Supported.
Max power consumption
• Tested—132 W.
• Theoretical—150 W.
LEDs
Table 68 LED description
LED Status Description
RUN
(green)
Off No power input is available or the SAP-28GE has failed.
Slow flashing (1 Hz) The SAP-28GE is operating correctly.
Fast flashing (8 Hz)
System software is being loaded or the SAP-28GE is not
operating.
CAUTION:
To avoid hardware damage, do not power off the router, or
insert or remove the SAP-28GE when system software is being
loaded.
Status LEDs for SFP
ports GE0 to GE15
(yellow/green)
Off No link is present.
Steady green A 1000 Mbps link is present.
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 100 Mbps.
Status LEDs for
combo copper ports
GE16 to GE27
(yellow/green)
Off No link is present.
Steady green A 1000 Mbps link is present.
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 10/100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 10/100 Mbps.
Status LEDs for
combo fiber ports
GE16 to GE27
(yellow/green)
Off No link is present.
Steady green A 1000 Mbps link is present.
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 100 Mbps.