Connecting a t1 interface cable, Appearance of the 4t1/8t1 splitter cable – H3C Technologies H3C SR6600-X User Manual
Page 73
Advertising
65
NOTE:
•
The Tx end of the cable must be connected to the Rx end of the peer device, and the Rx end of the cable
to the Tx end of the peer device.
•
The coaxial cable connector and 75-ohm E1 trunk cable are optional accessories to be separately
ordered if needed.
Connecting a T1 interface cable
Appearance of the 4T1/8T1 splitter cable
Figure 48 4T1 splitter cable
Figure 49 8T1 splitter cable
Advertising