Grass Valley 8900NET v.3.2.2 - Manual (Page 19)

8900NET Instruction Manual 19
Alarms and SNMP Monitoring
Note Disabled faults are still detected by the network GUI but LEDs will be inactive.
SNMP Monitoring
The Thomson Grass Valley Modular Control and Monitoring System uses
the Simple Network Monitoring Protocol (SNMP) internet standard for
reporting status information to remote monitoring stations. The SNMP
reporting from the 8900NET module provides status reports (traps) for
various frame and module faults and warnings as described in
Table 3 on
page 20 .
Status reports (traps) are unsolicited reports sent from the SMMP Agent to
one or more SNMP Managers such as Thomson Grass Valley’s NetCentral.
Once an SNMP agent has been installed, the 8900 frame and each module
slot can be configured to enable or disable these reports through the 8900
web pages.
Note The DIP switches described in Table 2 must be enabled for corresponding
SNMP reporting of the system components.
Table 2. 8900NET Configuration DIP Switch Settings
S1 Segment Left Position (open) Right Position (closed)
1 PS1 Fault Reporting Enabled PS1 Fault Reporting Disabled
2 PS2 Fault Reporting Enabled PS2 Fault Reporting Disabled
3 (Not used) Over Temp reporting is always enabled locally and through SNMP
4 Fan Fault Reporting Enabled Fan Fault Reporting Disabled
5 Module Fault Reporting Enabled Module Fault Reporting Disabled
6 Frame Bus Error Reporting Enabled Frame Bus Error Reporting Disabled
7 Fan Speed Controlled by Temperature Fan Speed Fixed at Maximum
8
Network Module Control Enabled (remote
control via GUI is enabled) Network Module GUI is placed in read only
mode
S2 Segment Left Position (open) Right Position (closed)
1
Status Enabled (enabled alarms are
reported over SNMP) SNMP Reporting is disabled except for
Over Temp alarm
2 IP Address (not currently supported)
3
Frame Control Enabled (remote control via
GUI is enabled) GUI for the frame and all modules within is
placed in read only mode
4 – 8 (Currently Not Used)