Grass Valley 8900NET v.3.2.2 - Manual (Page 35)

8900NET Instruction Manual 35
Using the 8900NET GUI
After reading the agreement, click on Accept to finish installing the SNMP
Agent ( Figure 20 ). Clicking the Decline button will abort the SNMP Agent
installation and return you to the Configuration web page.
Figure 20. Installing the SNMP Agent
When the SNMP Agent is successfully installed, the Configuration web
page will contain the setup items shown in
Figure 21 on page 36 .
Net Card SNMP Trap Reports
The following SNMP trap reports are provided for the 8900NET module:
• Net Card Status (Alarm)
• Hardware Switch (Informational)
SNMP Report Activation Modes
Each report destination has an activation control that can select one of the
following modes of operation:
• CREATE – GO creates a new report destination that becomes active after
the next module reboot.
• CREATE – WAIT creates a new report destination that remains out of
service until the user selects active and then reboots the module.
• ACTIVE changes a NOT IN SERVICE report destination to active after the next
module reboot.