Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 201)

Setting Marks
Profile Family 201
Setting Marks
To set a new in mark and out mark in a clip:
1. Click a panel to select it.
2. Create a clip, load a clip, or load a clip list and then select a clip from the list.
The Clip Position Bar is all the way to the left and the Timecode is
00:00:00:00.
3. Use the transport controls, drag the Clip Position Bar , or click on the
Timecode display to enter a timecode to locate the frame where you want to
set the in mark.
4. Click Set In Mark . The Timecode display remains the same, but the Clip
Position Bar jumps to the far left, indicating the mark-in point on the clip.
5. Use the transport controls, drag the Clip Position Bar , or click on the
Timecode display to enter a timecode to locate the frame where you want to
set the out mark.
6. Click Set Out Mark . The Timecode display remains the same, but the Clip
Position Bar jumps to the far right, indicating the mark-out point of the clip.
7. Drag the Clip Position Bar to the beginning of the clip.
8. Click Play . The clip starts at the in mark and stops at the out mark.
Removing Marks
To remove in and out marks from a clip:
1. Select a clip containing marks in the Clip Name box.
2. Click the Remove In Mark button to remove a mark-in point and reset the
clip beginning to the actual start of the clip.
3. Click the Remove Out Mark button to remove the mark-out point and reset
the clip ending to the actual end of the clip.
Trimming Clips
You can trim a clip from the beginning of the clip to the in mark or from the out
mark to the end of the clip. This action affects all copies of the clip on all panels.
The trimmed material is not retrievable. A warning message and verification
prompt are displayed before the function completes.