Connections – Bang & Olufsen BeoVision Avant - User Guide User Manual
Page 14
14
Connections
The connection panel on your
television allows you to connect
signal input cables as well as a
variety of extra equipment, such
as a DVD player or a music
system.
Equipment you connect to these
sockets can be registered in the
SOURCE LIST menu when you
press the red button. If the
equipment is not in the SOURCE
LIST, you must press the green
button to add it to the SOURCE
LIST first. For more information,
Before you connect any equipment to
your television, remember to disconnect
the television from the mains. Except
when connecting a source to the
HDMI IN or USB socket.
Depending on the type of equipment
you connect to the television, different
cables and maybe also adaptors are
needed. Cables and adaptors are
available from your Bang & Olufsen
retailer.
Tuner
If you use the hard disk recorder functions in
connection with a satellite dish, you must
use an LNB head with two outputs. If you
have more than one satellite dish, you must
also use a multi DISEqC switch. For more
information, contact your Bang & Olufsen
retailer.
Loudspeakers
Use Bang & Olufsen BeoLab speakers.
Cables are available from your Bang &
Olufsen retailer. You can also connect up to
eight speakers wirelessly.
To obtain the best possible wireless
connection, it is recommended to place all
wireless speakers within a range of
approximately 9 metres (29.5 ft) from the
television.
Do not place any obstacles in front of the
television or wireless speakers, as this may
interfere with the wireless connection. The
wireless speakers should be placed in one
room and be visible from the television. See
the guide for your speaker for information
about whether or not your speaker can be
connected wirelessly.
Equipment with HDMI™ output
Equipment with HDMI output such as a set-
top box can be connected to any available
HDMI socket in the television. For more
information on how to set up connected
equipment,
.
A configured source can be selected on the
BeoRemote One or in the SOURCE LIST. If
the television detects an unconfigured source,
you are asked to choose between doing
nothing, showing the source or configuring it.
Connected equipment can be operated with
its own remote control or you may download
a Peripheral Unit Controller (PUC) table, if
available, to use the Bang & Olufsen remote
control,
If you need to reset your television to default
settings, then bring up the REGIONAL
SETTINGS menu and select another country.
You will be asked to confirm the reset. All
settings will be deleted and you must go
through first-time setup, follow the on-
screen instructions.
AERIAL
SATELLITE
PL 1–5
SATELLITE