Loudspeaker setup – surround sound, More information – Bang & Olufsen BeoVision Avant - User Guide User Manual
Page 43
43
Loudspeaker setup – surround sound
Add BeoLab speakers and
BeoLab subwoofers to your
television wired or wirelessly and
you can have a surround sound
system which fits easily into your
living room. You get the best
sound experience in the area
bounded by the speakers.
You can also create speaker
groups to customise the speaker
setup for listening positions other
than the one in front of the
television, for example, at the
dining table or in an armchair.
This guide describes how to
make a basic loudspeaker setup.
For more advanced sound
settings and adjustments, see
the Technical Sound Guide on
For information about daily use
of speaker groups,
.
Your content provider may have
prohibited distribution of digital wireless
sound to your speakers. You must then
use wired Power Link connected speakers
instead.
Set up the speakers
Set up both wired and wireless speakers in
the television.
Wired speakers
When setting up wired speakers, you must
select which speakers you have connected
to each Power Link socket in the SPEAKER
CONNECTIONS menu.*
1
1
*If all Power Link sockets with connected
speakers are not shown in the SPEAKER
CONNECTIONS menu, you can press the
green button to show all Power Link sockets.
Important! If you select LINE as speaker type
in the SPEAKER CONNECTIONS list, the
volume will be very loud and you cannot
adjust volume with your BeoRemote One.
You must use the product’s own remote
control. LINE is used for, for example, non-
Bang & Olufsen amplifiers.
Wireless speakers
If you have wireless speakers in your setup,
the television automatically scans for
wireless speakers and associate the detected
speakers with wireless Power Link channels
during first-time setup. However, you can
also scan for wireless speakers and associate
the detected speakers with the television’s
wireless Power Link channels manually in the
SPEAKER CONNECTIONS menu.
Scan for and associate wireless
speakers …
In the SPEAKER
CONNECTIONS menu press to
rescan
When the scanning is
completed, press to associate
the detected speakers with the
television
Disassociate a speaker from the
television …
Select a speaker in the
SPEAKER CONNECTIONS
menu
Press once to be able to
disassociate the speaker. Press
again to confirm disassociation
If the state of a speaker is MISSING in the
SPEAKER CONNECTIONS menu, the speaker
has been associated with a wireless channel,
and will automatically be detected again
when possible.
MENU
SETUP
SOUND
SPEAKER CONNECTIONS
…
Continues …