Bang & Olufsen BeoVision Avant - User Guide - Manual (Page 18)

18
>> Connections
Before you connect a computer, you must
disconnect the television, the computer and
all connected equipment from the mains
supply. Connect a computer
> Using the appropriate type of cable,
connect one end to the DVI or HDMI
output socket on your computer, and the
other end to an HDMI IN socket on the
television.
> If you use the DVI output socket on the
computer, use the appropriate cable and
connect the digital sound output on the
computer to the S/P-DIF IN socket on the
television to hear sound from the
computer in the speakers connected to
the television.
> Reconnect the television, the computer,
and all connected equipment to the mains.
Remember, the computer must be
connected to a grounded wall outlet as
specified in its setting-up instructions.
Connect a computer
Connect an analogue source
You can connect one analogue source, such
as a game console or video tape recorder.
To configure equipment connected to the
television, see page 23 .
Disconnect all systems from the mains
before you connect additional equipment.
Connect an analogue source
> Connect the cable to the appropriate
socket on the equipment you wish to
connect.
> Run the cable to the AV IN socket on the
television.
> Reconnect the television and the
connected equipment to the mains.
> To enable remote control operation of the
analogue source, connect an IR-
transmitter to one of the PUC sockets and
attach it to the IR-receiver of the analogue
source.
See page 19 for more information
on IR-transmitters .
> Follow on-screen instructions to configure
the source.
Different adaptors and possibly also cables
are needed. Cables and adaptors are
available from your Bang & Olufsen retailer.