Epson Epson - Manual (Page 132)

Installing a Drive in an External Bay
Follow these steps to install a drive in an externally accessible
drive bay:
1. Reach inside the back of the drive bay and insert the
screwdriver into one of the holes in the metal plate
covering the drive bay slot. Move the screwdriver up and
down until the plate loosens; then grasp the plate with your
hands and pull it out of the back of the drive bay. Discard
the plate; you do not need to reinstall it.
2. Remove the plastic faceplate from the drive bay by pushing
it out from the inside of the computer. Keep the faceplate in
a safe place in case you remove a drive later (or you are
installing a hard disk drive).
3. Position the drive so the connectors face the back of the
computer.
Installing and Removing Tower Drives 6-11