Epson Epson - Manual (Page 32)

Starting the SETUP Program
When you start your computer, it performs some power-on
diagnostics. During these diagnostics, you may see the
following message:
P r e s s < D E L > t o e n t e r S E T U P
Press Del. This message is only on the screen for a few seconds.
If you missed it, restart your computer and try again.
If, during power-on diagnostics, the system detects an error in
your system configuration, you hear two beeps and see an
error message followed by this message:
Press <Fl> to resume, <DEL> to run SETUP
Press Del to run SETUP and correct the problem.
SETUP displays the Main Menu, which allows you to select
various options to identify your system’s configuration and
then save your new values. You can also cancel any changes
you have made and restore the default values stored in ROM or
load the previously stored values.
2-2 Running SETUP and Installing Drivers