Rosen Aviation 19-55 : Remote electronics - Manual (Page 23)

Rosen Aviation Remote Display System
Document Number: 105478 Revision: F
Date: 06/23/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 23 of 38
10.1. Advanced Technician Menu
This submenu provides installers and technicians more advanced controls of the image. From
the Technician Main Menu, highlight Advanced and then press ENTER.
Figure 24 Technician Advanced Menu
10.1.1. Factory Reset
Choose this option to perform a complete factory restore. It is similar to Reset Scheme in
the Main MenuAdvanced submenu; however, Factory Reset returns all options with
pre-determined defaults in both the User and Technician menus to their factory default
settings.
Highlight AdvancedFactory Reset and then press ENTER.
A Reset Complete message appears after the display restores the default settings. A
Factory Reset will not change the Operation Mode setting.
10.1.2. Viewing Angle
(Available on 19” RDM only) Use Viewing Angle to adjust the settings for viewing
angles from different seat positions. Changes to the Viewing Angle adjustment will affect
other UserImage Adjust settings.
Highlight AdvancedViewing Angle and then press ENTER.
Press the ◄ or ► to adjust the viewing angle in 5-degree increments from
-20 to +20 degrees.
Press ENTER to set the viewing angle and close the control bar.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT to exit the OSD.
Figure 25 Viewing Angle control bar
NA indicates that a
Composite signal is not
available
Available only
on a 19” RDM