Rosen Aviation 19-55 : Remote electronics - Manual (Page 26)

Rosen Aviation Remote Display System
Document Number: 105478 Revision: F
Date: 06/23/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 26 of 38
Power Mode cont.
Options include the following:

Ground-On:
The display always starts up in the ON state when the power pin is
set to ground, and it ignores all power commands from the IR, RS-232, and RS-
485. This setting will not take effect until you close the OSD.

Restore Previous:
The display returns to the previous power settings after any
power interruption.

Auto-On:
The display always starts up in the ON state when 28V is applied
(default when operating in Rosen RS-232 interface mode).

Auto-Off:
The display always starts up in the standby state when 28V is applied.
This setting requires a power command from the IR, RS-232, or RS-485 to turn the
display on.

Momentary:
The LCD power will toggle between on and off after the external
power discrete is momentarily grounded.

Open-On:
The display always starts up in the ON state when the power pin is
open (not grounded) and ignores all power commands from the IR, RS-232, and
RS-485. This setting will not take effect until you close the OSD.
Select Back and then press ENTER to return to the Technician Menu.
Press EXIT to exit the OSD.
10.2.2. Operation Mode
Use Operation mode to specify a default-operating mode. The Operation Mode setting
affects the OSD settings you will see and determines the factory default settings when
you perform a Factory Reset command.
From the Technician Menu, highlight Mode MenuOperation Mode, and then press
ENTER
.
Use the ▲▼ buttons to set the option, and then press ENTER. The screen will briefly go
black if you switch Operation Mode settings.
Options include the following:

Standard:
(Default) All video sources and functions are available. Power Mode will
default to Auto On.

Auto SDI:
The unit will always display SDI and use only a subset of OSD options.
The Power Mode will default to Ground On. See Power Mode on page 25 . If
Composite is connected, the unit will display Composite over SDI.
Table 3 Mode Menu settings
Operation Mode Power Mode Technician Menu
Standard Auto On Splash Screen &
Source Mode are ON
Auto SDI Ground On Splash Screen &
Source Mode are N/A