Rosen Aviation 19-55 : Remote electronics - Manual (Page 24)

Rosen Aviation Remote Display System
Document Number: 105478 Revision: F
Date: 06/23/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 24 of 38
10.1.3. Comp/RGB 1
Use Comp/RGB 1 to specify which input source the Component/RGB channel 1 will use.
The options for channel 1 to display are either Component or RGB.
Highlight AdvancedComp/RGB 1 and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
10.1.4. Comp/RGB 2
Use Comp/RGB 2 to specify which input source the Component/RGB channel 2 will use.
The options for channel 2 to display are either Component or RGB.
Highlight AdvancedComp/RGB 2 and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT to exit the OSD.
10.1.5. 3D Comb Filter
(Composite only)
When set to Enabled, the display will eliminate dot crawl and some
noise on stationary portions of the picture.
Highlight Advanced3D Comb Filter and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT to exit the OSD.
10.1.6. Composite Sig (Signal)
(Composite only)
This is a read-only screen that shows the signal strength of the
currently viewed Composite source. Composite Signal strength ranges from
0 to 1.25 Vpp in 0.25V increments. It will read NA (not available) if a Composite
source is not active or the AGC (Automatic Gain Control) (below) is set to Off.
10.1.7. AGC (Automatic Gain Control)
(Composite only)
This option is a signal compensation tool that will accommodate for
strong and weak Composite signals.
Highlight AdvancedAGC and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT to exit the OSD.