Subaru Robin RGD3300H - Manual (Page 28)

– 25 –
2 Control Box (1) Disconnect the coupler for key switch.
(2) Remove control box from frame by
removing the three bolts (6 ø) joining
the control box to frame and side plate.
Wire harness is still
connected. 10 mm spanner or
box spanner
(3) Put the control box with control panel
down.
Put a waste cloth
under the control
panel to protect it. 10 mm spanner
(4) Loosen the nut (4 ø) to remove the
ground wire (green/yellow) from the
rear of control box.
(5) Pull the bushing out from the control
box.
Step Part to remove Description Remarks Tool
COUPLER FOR KEY SWITCH
GENERATOR_GS2380.fm 25 ページ ２００７年１０月１日 月曜日 午前９時１３分